FMM-1 NOTIFIER MONITOR MODULE
FMM-1 NOTIFIER MONITOR MODULE
FMM-1 NOTIFIER MONITOR MODULE
  • Load image into Gallery viewer, FMM-1 NOTIFIER MONITOR MODULE
  • Load image into Gallery viewer, FMM-1 NOTIFIER MONITOR MODULE
  • Load image into Gallery viewer, FMM-1 NOTIFIER MONITOR MODULE

FMM-1 NOTIFIER MONITOR MODULE

Regular price
$95.95
Sale price
$95.95
Regular price
Sold out
Unit price
per 
Shipping calculated at checkout.

FMM-1 Notifier is a standard-sized module (typically mounts to a 4″ [10.16 cm] square box) that supervises either a Style D (Class A) or Style B (Class B) circuit of dry-contact input devices.

FMM-1(A) Monitor Module

  • Built-in type identification automatically identifies this device as a monitor module to the control panel.
  • Powered directly by two-wire SLC loop. No additional power required.
  • High noise (EMF/RFI) immunity.
  • SEMS screws with clamping plates for ease of wiring.
  • Direct-dial entry of address: 01 – 159 on FlashScan loops; 01 – 99 on CLIP loops.
  • LED flashes green during normal operation (programmable option) and latches on steady red to indicate alarm.

The FMM-1(A) Monitor Module is intended for use in intelligent, two-wire systems, where the individual address of each module is selected using the built-in rotary switches. It provides either a two-wire or four-wire fault-tolerant Initiating Device Circuit (IDC) for normally-open-contact fire alarm and supervisory devices. The module has a panel-controlled LED indicator. The FMM-1(A) can be used to replace MMX-1(A) modules in existing systems.

FMM-1 Notifier Applications

Use to monitor a zone of four-wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally open dry-contact alarm activation devices. May also be used to monitor normally-open supervisory devices with special supervisory indication at the control panel. Monitored circuit may be wired as an NFPA Style B (Class B) or Style D (Class A) Initiating Device Circuit. A 47K Ohm End-of-Line Resistor (provided) terminates the Style B circuit. No resistor is required for supervision of the Style D circuit.

FMM-1 Notifier Operation

Each FMM-1(A) uses one of the available module addresses on an SLC loop. It responds to regular polls from the control panel and reports its type and the status (open/normal/short) of its Initiating Device Circuit (IDC). A flashing LED indicates that the module is in communication with the control panel. The LED latches steady on alarm (subject to current limitations on the loop).

Monitor Modules with FlashScan Data Sheet